*All prices are in Canadian funds.
Makerbot Translucent Purple PLA 1.75mm Print Filament 1Kg Spool (205145)
MakerBot PLA Filament is the best, safest, and most consistent filament for the MakerBot Replicator 2 Desktop 3D Printer. MakerBot PLA Filament is a renewable bioplastic made from corn. All its dyes are FDA-approved as food safe and it's guaranteed to have no heavy metals, phthalates, or BPA. Color: Translucent Purple
Every filament color is comprehensively quality tested at both 100-micron and 200-micron layer resolutions on the MakerBot Replicator 2 to verify that the filament will perform every feature that MakerBot® MakerWare software offers and reliably slice and print every type of printing.
If you're new to 3D printing, MakerBot PLA Filament is a good material to start with because it's easy to use and performs well on most prints.
MakerBot PLA Filament adheres well to acrylic and to blue painter's tape. Prints with a large bottom layer may have a tendency to curl. To prevent curling, use rafts.
Store MakerBot PLA Filament in a cool, dry place as it can absorb moisture from the air and long-term exposure to humidity can compromise filament quality and performances.
Be sure your build plate is level, clean and oil-free before printing.
60~65° C (140~149° F)
150~160° C (302~320° F)
230° C (446° F)
DIMENSIONS & WEIGHTS:
SPOOL HUB HOLE
1 KG (2.2 LB)
XTC-3D Print Epoxy Coating
SO-Strong Urethane Pigments
UVO Color Pigments
Ignite Fluorescent Color Pigments
Glow Worm Powders
Cast Magic Powders